• Al Launier

    There is no available content written by Al Launier
  • Recent Polls

  • Recent Forum Posts

    John TenEyck

    What clear coat to use

    You shouldn't need to put anything over either of those products but if you want to anyway then I would use a clear version of the same stuff, respectively,

    John TenEyck Today, 3:10 PM Go to last post
    Kyle Iwamoto

    Don't know

    Ok, I'll toss in my worthless $0.02. Mount it on the lathe and start turning. Perhaps it will come to you what it wants to become. Everything you turn

    Kyle Iwamoto Today, 3:09 PM Go to last post
    Mel Fulks

    How to production sand Pine faster ?

    At least one of the pattern makers supply houses sells a "pitch solvent" that cleans sandpaper. I don't know if it would
    disolve the

    Mel Fulks Today, 2:27 PM Go to last post
    David Kumm

    Planer design differences

    Patrick, I'm not sure that the upgrade between the two PM machines would cure your issues either. It may not be the design, but the execution that is

    David Kumm Today, 2:25 PM Go to last post
    steven c newman

    A new Desk for me

    Top has been cleared off....beltsanded, ROS sanded, and finally..

    Wiped down. Corners out front were rounded...

    Sabresaw is

    steven c newman Today, 2:20 PM Go to last post
  • Recent Blog Posts