• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 9:39 PM Go to last post
    Thomas Wilson

    Rules of Thumb for Workshop Size

    Thread Starter: Thomas Wilson

    Hi all, I am a new member and this is my first question. I am about to build a new garage/workshop to house my tools that are currently scattered in several locations because I have outgrown my 18x26 basement shop. I have worked on general arrangements of a functional shop but I am coming up...

    Last Post By: Thomas Wilson Yesterday, 11:15 AM Go to last post
    Thomas Crawford

    restoring a powermatic 15HH

    Thread Starter: Thomas Crawford

    So this thing followed me home finally last week. Its a bit of a mess but I'm hoping I can get it all cleaned up.

    Last Post By: Matt Day Yesterday, 5:02 PM Go to last post
    Ollie McDottie

    Why a 12" jointer?

    Thread Starter: Ollie McDottie

    I'm in the market for a new jointer. So obviously, I've spent an inordinate amount of time reading up on the options/opinions. Currently I'm waffling between an 8" Powermatic HH parallelogram and Laguna 12" HH parallelogram. Blog after blog, forum upon forum, folks seem to all say bigger is better....

    Last Post By: Rod Sheridan Yesterday, 1:13 PM Go to last post
    Tim Derr

    Felder Group USA Support

    Thread Starter: Tim Derr

    Let's talk. Good Day Creek! I wanted to reach out to you all and let you know that I will be taking over on the forums for Felder Group. My name is Tim Derr and if you ever need anything,...

    Last Post By: Dan Friedrichs Yesterday, 7:47 PM Go to last post
    Tony Zona

    Your knowledge, please

    Thread Starter: Tony Zona

    Frank Howarth, prominent on Youtube, uses his huge CNC sometimes to whip out a small part or two. My question, not considering the hardware: What does it take to make a small part? Say you want to cut four donuts of 3/4” plywood. How long does it take to design that job, and what software do...

    Last Post By: David Buchhauser Today, 12:34 AM Go to last post
  • Edward Dyas

    There is no available content written by Edward Dyas