I have a 1/2" sorby detail gouge that I have ground at 40° (also removed the heel) and it works ok now that I moved away from the jigs and started sharpening by hand... but it's still just an ok tool. I now have a d-way detail spindle gouge (1/2") on the way and was thinking about trying a 25°...
Last Post By: Don Frank Today, 8:57 AMHas any one here done one? Looking for suggestions, thanks.
Last Post By: Brian Holcombe Today, 3:02 PMAll, I have been in the market for a bigger bandsaw. Starting to build some rocking chairs a la Hal Taylor, and my PM 141 does not have enough clearance to make a few of the cuts needed. A Powermatic 80 20" had come up in my area, for a little under $1k. Owner states it runs smooth, cuts well....
Last Post By: Mickey Plunkett Today, 11:47 AMhttps://www.cnn.com/2024/05/07/business/swiss-army-knife-blade-scli-intl/index.html While I understand the decision, I can't help think that, I carry a pocket knife, with a blade only and use it for so many tasks. I think I would be fumbling through the selection of tools trying to find a...
Last Post By: Warren Lake Today, 12:10 PMI used to feel frustrated when I would have listed something for sale on Craigslist or Facebook and included the town where I lived, and instead of looking it up on their devices people would write to me to ask "where is Orwell" (where I used to live) or now "where is Piercefield?". I finally...
Last Post By: Cameron Wood Today, 3:14 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Looking for some assistance from Miller Falls folks.
I bought a lot of 6 block planes off my usual auction site. The planes were listed
First place I always look is is tag on motor, if corners going to be cut that’s usually where start. Well it’s where I look anyway
Carroll Courtney Today, 3:41 PMHow do you achieve fine placement of the blast for more precise or delicate work?
Are the air volumes required still the same.
How about PU glue? Might that work? It will, reputedly, glue together almost anything ... although it might be difficult to work with and I have no idea
David Storer Today, 3:37 PMGood afternoon guys, while back Tom help me with selecting a penetrating epoxy Total Boat. Since this is first time I ever use epoxy I like to stay with
Carroll Courtney Today, 3:29 PM
Harvey Slider on Unisaw?
Thread Starter: John KananisAll these slider threads got me thinking. Does anyone here have the Harvey compass st-1500 attached to their unisaw? Can you speak on the quality, ease of attachment, capabilities and shortcomings? Thank you in advance!
Last Post By: John Kananis Today, 10:40 AM