• Jim Becker

    There is no available content written by Jim Becker
  • Recent Polls

    Which fence: (Votes: 12)

    1. Delta Biesemeyer 78919B Type 2 (Votes: 2)

    2. SawStop TGP2-FA (Votes: 6)

    3. Something else (Votes: 4)

  • Recent Forum Posts

    Scott Winners

    How to?

    I still need a picture. Is the table top square/rectangular and the framing L shaped with a third member (leg) coming into the joint at a corner, or

    Scott Winners Today, 1:48 AM Go to last post
    Mel Fulks

    cutting sandpaper roll

    Score the PAPER side with a utility knife ,then bend ...to break

    Mel Fulks Today, 1:46 AM Go to last post
    Jim Koepke

    The President Whom No One Voted For

    Easy and already answered.

    What many do not realise is we have had one President who was born a King.

    Some likely know the

    Jim Koepke Today, 1:37 AM Go to last post
    Jim Koepke

    How to?

    Cut across the grain first. This becomes the stop cut when cutting with the grain.

    Some like to drill out the waste and do the clean up and

    Jim Koepke Today, 1:28 AM Go to last post
    Jim Koepke

    Edge joinery with tongue and groove

    That sounds like the traditional construction of case work.

    Then there is at least a dozen ways to make the panels.

    jtk

    Jim Koepke Today, 1:23 AM Go to last post
  • Recent Blog Posts

    Bob Riefer

    would this shop improvement be "worth it"?

    hmmmm. Very good thought. Last few years hasnít had much cold weather but I agree with your idea of
    covering the stairs being beneficial. Thanks!!

    Bob Riefer 10-04-2020 10:11 PM