• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Koepke Today, 12:56 AM Go to last post
    Jacob Mac

    Hammer K3 Winner 48x48 thoughts?

    Thread Starter: Jacob Mac

    I'm kicking around getting the Hammer K3 Winner 48x48 sliding table saw. Does anyone have one? Experience with it? Better options in the $5,000 price range? I suppose the Sawstop and the Minimax SC2 are probably the other contenders. I'm tracking that used is always an option, just tough to...

    Last Post By: Rod Sheridan Today, 2:58 PM Go to last post
    Erik Loza

    HAMMER (Felder) news

    Thread Starter: Erik Loza

    I know there are lots of Hammer customers here, so wanted to share some news from Felder KG: -Lead times continue to be a challenge but I found this very interesting: Austria hired something like 100 more workers for the production line, specifically for Hammer machines. Believe this or not,...

    Last Post By: Erik Loza Yesterday, 4:08 PM Go to last post
    derek labian

    Advice on sagging Jointer table (MM FS41ES)

    Thread Starter: derek labian

    I have a sagging jointer in-feed table table that is producing concave joints (cup in the middle). This is a new MM FS41ES so this has been happening since production. Since I assumed it was factory adjusted, I thought it was my technic but its clear now its the in-feed table. Just incase anyone is...

    Last Post By: Erik Loza Today, 2:47 PM Go to last post
    derek labian

    Mobile/Storable CNC for small shop

    Thread Starter: derek labian

    I've been looking at various CNC's that are relatively small and portable. Shark 2x4 (Rockler) Powermatic 2x4 Avid 2x4 and 4x4 Camaster 2x4 Stinger I and II In general: There are so many options, features, and addons its hard determine what might be the best general purpose unit. I'd like...

    Last Post By: Mark Bolton Today, 2:55 PM Go to last post
    Matt Culik

    Sliding Table Saw - Why Slider Above Table?

    Thread Starter: Matt Culik

    Hi. I have a Grizzly G0623X sliding table saw. I use the slider side 90% of the time, and I've got it pretty well dialed in thinks to the folks on this forum and YouTube. One of the things mentioned by a variety of folks is that the sliding table should be planar to but ~0.010" ABOVE the table saw...

    Last Post By: Chris Parks Yesterday, 8:48 PM Go to last post
  • Jim Becker

    There is no available content written by Jim Becker