• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Allen Yesterday, 1:19 PM Go to last post
    david charlesworth

    There's nothing wrong with A2

    Thread Starter: david charlesworth

    I frequently hear that A2 is difficult to sharpen with a wire edge which hangs on. My sharpening method is very simple. Get a small wire edge at 30 or 33 degrees . An Eclipse honing guide is used, with an 800 grit man made Waterstone. The angle is then raised by about 2-3 degrees Now 4...

    Last Post By: ken hatch Today, 6:57 AM Go to last post
    John Pariseau

    Load Center for "new" shop

    Thread Starter: John Pariseau

    I completed (passed final inspection) last October (2019), and I'm getting ready to start electrifying my shop. I had decided early on pulling a building permit that included electric, was too much for me to do in one pass - I'm very glad I made that decision. I've done some research here and on a...

    Last Post By: glenn bradley Yesterday, 2:17 PM Go to last post
    steven c newman

    A Project for July?

    Thread Starter: steven c newman

    Well....I did have a stack or two of scraps... And a couple of Pine boards sitting around, doing nothing constructive And a couple handy panels of plywood.... That needed a job. Sorted through the Ash scraps....had 11 pieces, tossed out 2...They needed squared up, so they were all about...

    Last Post By: steven c newman Yesterday, 9:22 PM Go to last post
    Dan Kraakenes

    Puting in a order for clamps.. am I missing anything?

    Thread Starter: Dan Kraakenes

    Im about to put in my order for a bunch of clamps. See any thing that I would be missing? I want a I beam clamp for gluing.. but I suspect the parallel clamps will handle it fine. This is for a hobby shop.. not any commercial endeavor, with mostly hand tools. K-body / Parallel 8 x 50" 8...

    Last Post By: Jim Becker Yesterday, 1:46 PM Go to last post
    Brian Elfert

    What roller covers for contact cement?

    Thread Starter: Brian Elfert

    I am currently applying a bunch of the high VOC contact cement for a project. About a gallon worth so far. I bought a batch of 12 cheap roller covers from Amazon. The mine ones about four inches wide with just a metal rod. My problem is the roller covers keep coming apart. I used up five...

    Last Post By: Brian Elfert Yesterday, 10:30 AM Go to last post
  • Jim Becker

    There is no available content written by Jim Becker