• Jim Becker

    There is no available content written by Jim Becker
  • Recent Polls

    Which fence: (Votes: 12)

    1. Delta Biesemeyer 78919B Type 2 (Votes: 2)

    2. SawStop TGP2-FA (Votes: 6)

    3. Something else (Votes: 4)

  • Recent Forum Posts

    Doug Dawson

    Under Bench Parallel Clamp Storage ????

    Once you have some of these clamps, youíre going to get more of them. Storing them under the bench is going to get really old once you start using them.

    Doug Dawson Today, 3:50 AM Go to last post
    Derek Cohen

    LN Sharpening Jig

    I am not capable of determining or differentiating by eye a bevel angle of 45- versus 50 degrees, and then freehanding a micro secondary bevel with a

    Derek Cohen Today, 2:53 AM Go to last post
    Kev Williams

    alternative to ezcad?

    At this time I'm working on a bunch of parts that the manufacturer can't engrave themselves because their fiber laser quit. Again. Last time was only

    Kev Williams Today, 1:36 AM Go to last post
    Bob Hinden

    Bandsaw Issue

    Thanks to the helpful suggestions. I got it working with the 1/4" blade.

    I think the underlying problem what that the blade and the

    Bob Hinden Today, 1:32 AM Go to last post
    David Buchhauser

    Pocket Toolpath Concerns

    Hi Ronald,
    Here is one way to do it.

    Step 1 - Select the two closed paths shown below.

    David Buchhauser Today, 1:16 AM Go to last post
  • Recent Blog Posts

    Bob Riefer

    would this shop improvement be "worth it"?

    hmmmm. Very good thought. Last few years hasnít had much cold weather but I agree with your idea of
    covering the stairs being beneficial. Thanks!!

    Bob Riefer 10-04-2020 10:11 PM