I'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: Sam Force Today, 9:43 AMThey are going crazy building standalone car washes in my area. I know of at least three currently under construction nearby, and a few others that recently opened. Car washes are going up all over the Minneapolis metro area. There will easily be three times as many standalone car washes once...
Last Post By: Jim Becker Yesterday, 8:10 PMI glued up this oval Santos mahogany coffee table on Sunday. Yesterday morning, Tuesday, I placed it outside under cloudy skies in the hope that the UV to hasten the darkening of wood surface before finishing later this week. The center seam opened up. I used brand new T-88 epoxy with...
Last Post By: Mark Gibney Yesterday, 6:33 PMMy landscape guys clean up the beds and install mulch for me now, too old, but I planted everything you see except the very large mature trees. Shade garden, cutting garden, front. Thanks Brian
Last Post By: julian abram Yesterday, 8:32 PMhttps://www.ktnv.com/news/park-rangers-looking-for-two-vandalism-suspects-at-lake-mead-national-recreation-area What the ____ is wrong with some people?
Last Post By: Doug Garson Today, 12:13 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
I have a Powermatic DS20 that is similar to what you describe on start up only also. I think it is a current inrush that causes it. With mine it is closer
Robert Hayward Today, 12:25 PMHollow Mortise Chisels 1/4" and 5/16", plus large cone sharpeners - purchased from Lee Valley about a year ago, but they never came out of
Andy Jungblut Today, 12:09 PMThe public wifi concerns are wildly overblown. You are fine to use a Starbucks wifi with your laptop.
https://wapo.st/3UKVc4e
I have several bowl gouges, from several manufacturers. I know folks measure flutes differently, how do you know when ordering a new gouge how it’s measured.
mike johnston Today, 12:06 PMYou might want to look into a Dispos-a-Blade system if you get the Dewalt. I installed it on my 12" jointer and it leaves a glass smooth finish.
Rob Sack Today, 11:54 AM
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Michael Burnside Today, 11:31 AM