• Steven Lee, NC

    There is no available content written by Steven Lee, NC
  • Recent Polls

  • Recent Forum Posts

    Derek Meyer

    6-1/4 Circular Saw Regrets?

    I have the Dewalt 20V cordless 6.5" saw, and before that the 18V 4.5" and 5" saws. The old saws were fine for sheet goods - I used them

    Derek Meyer Today, 5:47 PM Go to last post
    Jeff Roltgen

    Large thread only 3 pages

    I get the same results. Have noticed this on many others. Sorry- don't know why. In some cases, I can scroll to the outline above, click the "more

    Jeff Roltgen Today, 5:45 PM Go to last post
    Dave Fritz

    Live Streaming

    Thank you Ronald. This school uses boxcast https://www.boxcast.com/ to stream. The college did send me a link to an archived copy so we can watch it later.

    Dave Fritz Today, 5:38 PM Go to last post
    Bernie Kopfer

    Powermatic 3520b quill problem

    Thanks for the suggestions but I ordered a new one. I perhaps too hastily presumed it was non restorable. Two reasons , it really bound up tight half

    Bernie Kopfer Today, 5:31 PM Go to last post
    Tai Fu

    air compressor VFD control

    Actually I do have a question...

    So let's say you got a rotary phase converter running. But you want to start something that may have a higher

    Tai Fu Today, 5:16 PM Go to last post
  • Recent Blog Posts