Due to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Bert McMahan Today, 9:30 PMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Jim Becker Today, 7:11 PMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Perry Holbrook Today, 9:10 PMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Jim Becker Today, 1:18 PMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Today, 6:59 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Could you send a pic of the radiused square carbide tool? I'm not very familiar with AZ Carbide. Also, what size and how much are the Nova cole jaws (if
Bert McMahan Today, 9:30 PMIve seen some you tubes past hooked up to welders and the ones I saw didnt work.
Warren Lake Today, 9:25 PMPlacing baking soda in a battery would neutralize the acid in the battery, so that would pretty much doom the battery.
Lee Schierer Today, 9:18 PMI had the same BTC purchase email. I marked it as spam and blocked all future emails from that domain
Lee Schierer Today, 9:15 PMI would get phone calls telling me that my Amazon purchase (always between $700-$999) needs more info.
Patty Hann Today, 9:10 PM
Lumber supply
Thread Starter: steven c newmanHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 7:10 PM