• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Allen Today, 5:53 PM Go to last post
    John Pariseau

    Load Center for "new" shop

    Thread Starter: John Pariseau

    I completed (passed final inspection) last October (2019), and I'm getting ready to start electrifying my shop. I had decided early on pulling a building permit that included electric, was too much for me to do in one pass - I'm very glad I made that decision. I've done some research here and on a...

    Last Post By: Jim Becker Yesterday, 7:38 PM Go to last post
    Todd Sebek

    Help buying my first bandsaw(s)

    Thread Starter: Todd Sebek

    Hey everyone, I am new to this forum but have researched through it for a while. What a great resource. I need yíallís advice. I am an amateur/beginner woodworker but truly value quality tools. My understanding wife has allowed me to try to purchase ďforeverĒ tools this year. Again, Iím an...

    Last Post By: Mike Kees Yesterday, 9:02 PM Go to last post
    Frederick Skelly

    Do YOU use handscrew clamps?

    Thread Starter: Frederick Skelly

    There's another thread where a guy in europe is buying a bunch of clamps and asked for advice. There's some back and forth about wooden handscrew clamps. (Like these) One man says everybody has some but most people don't use them often. Another man says he uses them for a lot of things. I didnt...

    Last Post By: John K Jordan Yesterday, 8:36 PM Go to last post
    Dan Kraakenes

    Veritas LA/BU planes or Custom planes?

    Thread Starter: Dan Kraakenes

    Im considering upgrading my single plane to more dedicated 4,5,7 planes. Im currently used to a #4, but I have to large hands for it, so was first thinking of upgrading to a 4 1/2. But.. then again I am wondering if I should go for the Low Angle / Bevel up planes or the "Custom" Veritas...

    Last Post By: Dan Kraakenes Today, 3:51 PM Go to last post
    Phillip Mitchell

    Pocket hole jig recommendations for production trim

    Thread Starter: Phillip Mitchell

    I have a portion of a job coming up in the next handful of weeks where Iím planning to preassemble about 30 windows (+ dozens of doors) worth of casing trim and am considering pocket screws on the back side of the casing where the leg and head / bottom casing joint comes together. This trim will...

    Last Post By: Dave Sabo Today, 2:01 PM Go to last post
  • Rich Harman

    There is no available content written by Rich Harman