Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 4:51 PMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Wes Grass Today, 3:26 PMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Lee Schierer Today, 7:28 AMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Bill George Today, 9:51 AMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Keith Outten Today, 7:27 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
When I was in high school I worked at the local lumber/ hardware and was in charge of sash repair. We had an L shaped device about 1ft x 6 inches with
Bradley Gray Today, 7:59 PMThanks for the suggestions. I wound up using my oscillating saw, took about 1/2 hour. I don't know how a wire would work in a rabbet; a very thin hot
Kevin Jenness Today, 7:50 PMBill, I have to source motors for work. Had very good luck on eBay over the years. Helps if you can be patient, most of the time that is not the case.
Ron Selzer Today, 7:03 PMThe exceptions to the rules confuse some folks. The possessive its has no apostrophe the contraction it's does.
My own rule for verbs vs
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 11:03 AM