I used to feel frustrated when I would have listed something for sale on Craigslist or Facebook and included the town where I lived, and instead of looking it up on their devices people would write to me to ask "where is Orwell" (where I used to live) or now "where is Piercefield?". I finally...
Last Post By: Patty Hann Yesterday, 11:12 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 11:58 AMGreetings All, I’ve done a search here, but all the threads I have seen are old. I would like a recommendation for an adhesive with a long open time for complicated glue ups, minimum 30 minutes,. I typically use Titebond 3 but would like more time for some projects. Sometimes it’s possible to do...
Last Post By: Wes Grass Yesterday, 11:14 PMI recently sold a machine I didn't need and now can repurpose that money into something else. I recently got a Sawstop and was thinking of the Harvey sliding table attachment for it. Expensive but it sure looks like the build quality is first class. You essentially get the Harvey miter gauge as...
Last Post By: Darrell Bade Yesterday, 11:50 PMI have a baldor 7.5HP BALDOR 3450RPM 213T TEFC 1PH MOTOR L3709Ton my table saw. What type of grease should I look for to put grease in the grease or zirk fitting?
Last Post By: Brian Runau Today, 9:01 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
If there is a Menards near you, they have Red Devil Triangle Glazing Points listed > https://www.menards.com/main/paint/p...474-c-8076.htm
Jim Koepke Today, 3:46 PMI have this buffer and need an adhesive backed hook & loop pad to stick to the 6'' disc. The disc does not come off, as far as I can tell. I wish
Jerry Thompson Today, 3:22 PMIt doesn't fit at all it was just a flat landing spot at the time and I didn't have a spot for it at the time of the picture.
Tom Bussey Today, 3:11 PMOK but I'm looking for a controller to turn the fans off and on. A heat exchanger is just a piece of hardware, not a controller. A pair of fans with
Doug Garson Today, 2:38 PM
Milling machine as a mortiser
Thread Starter: andrew whickerHi all, I don't look often, but when I do it seems there are absolutely no used mortising machines out there. Something I've always wanted (someday) was a knee mill. There's a place near me that has had a Cincinnati Contour Master for sale forever (years and years). They re build these...
Last Post By: Bob Vaughan Today, 1:58 PM