Sawmill Creek Woodworking Community

Sections
Sawmill Creek News

Workshops

Woodturning

Social Woodworking

Tools

Lathes and Accessories

Table Saws and Accessories

Jigs and Fixtures

Cabinetry
Recent Articles
Recent Article Comments Widget
Hottest Threads

Time for some levity
Thread Starter: Dave Anderson NH
With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Mike Soaper Yesterday, 10:30 PM

New solid body electric guitar
Thread Starter: roger wiegand
I hope to make periodic posts through this build, the Day designations will, I expect refer to days of posts rather than day of build, perhaps like some people interpret biblical "days" of creation. Too many other projects happening at the same time! I built a bass with my son most of a decade ago,...
Last Post By: David Falkner Yesterday, 8:32 AM

Any chance of construction lumber prices going down in six months?
Thread Starter: Bill Dufour
Lumber is about 100% higher with covid since 12 months ago. More homes are starting to be built. Any thoughts on construction lumber prices in the next 12 months? Bill D
Last Post By: William Bell Yesterday, 9:38 PM

A Building Appears
Thread Starter: glenn bradley
My patience is tested by the 2-pics-at-a-time feature so this will be brief.
Last Post By: Bill Carey Yesterday, 11:20 AM

Vaccination Arm
Thread Starter: Tom Bender
Don't get your Covid Vaccination in your toilet paper arm.
Last Post By: Lee DeRaud Yesterday, 7:32 PM

Track Saw vs Circular Saw vs Table saw Vs Miter saw - Which one to start with?
Thread Starter: Amelia Green
Hi, I realise that all tools are not equal. I remember someone saying that even a table saw does not equal a table saw does not equal a table saw :eek: But if someone is just getting into the woodworking hobby with a limited space available for the workshop, which one would you guys recommend...
Last Post By: Alex Zeller Yesterday, 12:52 PM

Dave Dunn

There is no available content written by Dave Dunn

Recent Polls
Do you twist your wires before using a wire nut? (Votes: 48)

Yes (Votes: 36)

No (Votes: 12)
Recent Forum Posts

Boy, don't post in the Metalworking forum

I am very pleased to report that my anonymous benefactor's steel has arrived. "They" sent me not one but two plates, one with vertical grain
Bob Jones 5443 Today, 12:06 AM

Grain orientation wedged round M&T

There might be a good reason that you cant explain the " grain thing"
Mark Hennebury Yesterday, 11:48 PM

Grain orientation wedged round M&T

William, sketch this out for me, because it makes no sense.

"Driving the wedge against the grain of the tenon will have the greatest
Mark Hennebury Yesterday, 11:42 PM

Delta vs Jet

To Rich and to others viewing this thread,
the following post does not represent an indorsement, nor as a critique of the following brands. Ed
Ed Edwards Yesterday, 11:40 PM

1/8" Glass in 1/4" Groove - Kitchen Cabinet Doors

+1 to Richard's opinion. Always a rabbet, never a groove or dado. I use 1/4 x 1/4" lengths of wood (same species and finish) and pin nail these
Thomas McCurnin Yesterday, 10:51 PM
Recent Blog Posts

Sections

Recent Articles

Recent Article Comments Widget

Hottest Threads

Dave Dunn

Recent Polls

Recent Forum Posts

Recent Blog Posts