I'll finally be non-nomadic, and I'd like to finally build up a workshop. Before I get started, I'd love to get ideas. I'd love to see how you do things, and how you do things differently with all the disciplines here: tuners, neanders, power tool users, festoolies, etc. For those of you who...
Last Post By: Maurice Mcmurry Today, 11:04 AMLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Alan Lightstone Today, 1:11 PMI'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: Edward Weber Today, 4:40 PMI just ordered a dozen pencil sharpeners for 12$ from Amazon. These should last me through the small project I have on the back burner.:D
Last Post By: Jim Koepke Today, 12:08 AMI have needed a long measuring tool that is rigid for checking square on doors (measuring the diagonals). I bought this a bit reluctantly because it is in three pieces and I don’t normally trust rulers that come apart. This is dead-on accurate and the joints where it comes together are precision...
Last Post By: Andrew Hughes Yesterday, 7:39 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
I'm once again in the same camp.
My guides will probably never wear out because they hardly ever turn.
If I see one of the bearings start
Looks like I let my subscription lapse, so I can't see the image. I'll do a little searching for that article, thanks for suggesting it!
Always saw bandsaws mostly italian at auctions for 750.00 to maybe 1,200.00. they were working in production at the time and most needed nothing. All
Warren Lake Today, 4:37 PMI'm not seeing a whole lot on the used market. The Laguna LT16 SEC (Meber) and a Mini Max E16 (Centauro) have popped up. Both look to be in really good
Jimmy Harris Today, 4:30 PMThanks all for the suggestions. I tried Ken’s wedge method first and that got the CNN wheel off. The flange is still stuck I'll try penetrating
Luis Reyes Today, 4:23 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 11:38 AM