• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Jim Becker Today, 1:10 PM Go to last post
    Dan Friedrichs

    "Professional" paint (Sherwin Williams, etc) vs Box-Store paint

    Thread Starter: Dan Friedrichs

    In our new house, I bought Valspar Signature paint from Lowe's to paint the entire interior, but ended up hiring professional painters to do the job. Nice, honest guys, who very timidly pulled me aside after putting on 2 coats of the Valspar and asked if I'd be offended if they went and bought...

    Last Post By: lowell holmes Today, 12:38 PM Go to last post
    Bennie Dempsey

    3D Planning Software

    Thread Starter: Bennie Dempsey

    Hey all! I would like to start planning out my projects before I begin them, as I've heard that's a good habit to have. I can find a modeling program online pretty easily, but I wanted to see what you guys use. I am awful at hand drafting so paper and pencil isn't my go-to for personal projects....

    Last Post By: richard b miller Today, 11:05 AM Go to last post
    Larry Frank

    Dust Bin Sensor Completed

    Thread Starter: Larry Frank

    After reading all of the fine work by several members, I decided that I wanted to add the dust bin sensor to my Oneida Super Dust Gorilla. I ordered most of the parts on eBay. The sensor was $3.79, the delay relay board was $4.95 and the 12 V power supply was $9.99. I used some LED trailer...

    Last Post By: Bob Hinden Yesterday, 7:37 PM Go to last post
    Michael Gantz

    Hanging EMT conduit in new shop.

    Thread Starter: Michael Gantz

    I'm currently in the process of building a 24' x 36' shop with 10' ceilings. The walls are 2" x 6" studs and the cavities are filled with cellulose insulation. The walls are covered in 1/2" drywall. My intention is to minimize wall penetrations to keep air leaks to a minimum. The plan is to...

    Last Post By: Julie Moriarty Today, 1:19 PM Go to last post
    Dave Lehnert

    New Zero Turn Mower

    Thread Starter: Dave Lehnert

    Starting to think about a new Zero Turn Mower. I now own a Toro 52" with a 19 Hp Kawasaki that I have been happy with. Mow 2 1/2 acr all flat. What brand have you been happy with? More important. Is there a brand you have had trouble with? Parts hard to get etc.....

    Last Post By: Ronald Blue Today, 12:50 PM Go to last post