Has been restocked..
Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox...
Eight 1 x 6 x 6'
Five 1 x 4 x 6'
And he threw in a stack of shorts
And a 3/4" x 8" x 39" slab..
I am looking for what people in other jurisdictions have dealt with. I have always understood that, in my city, fences between homes were the responsibility of the homeowner who first puts it up. And the rule was "good side out" and 6" off the property line. But after a discussion with a...
Hi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions.
Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Saw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall.
It will probably take ten to twenty years until this ban goes...
All -
Has anyone seen or used the Harvey COMPASS RG-1/RG-2 Universal roller guides.
They look solid and would be a pretty useful addition to my shop, but the price seems way too high.
I'd love to hear any feedback.
Thanks.
I have a baldor 7.5HP BALDOR 3450RPM 213T TEFC 1PH MOTOR L3709Ton my table saw. What type of grease should I look for to put grease in the grease or zirk fitting?
It seems like Timberwolf blades are one of those things that most swear by, some swear at. As far as blade width, I'd take the manufacturer's rated width
Sections
Recent Articles
Recent Article Comments Widget
Recent Polls
Recent Blog Posts
Lumber supply
Thread Starter: steven c newmanHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 11:20 PM