• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 10:42 PM Go to last post
    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Mike Heidrick Yesterday, 9:27 PM Go to last post
    Patrick Irish

    Justifying tool purchases for Hobby Work

    Thread Starter: Patrick Irish

    My 9-5 is special education assessments. Keeps me busy and I take a good amount of work home. We're having our first child end of June which will add a completely different dynamic to our lives. Buddy of mine had a good point regarding spending money on expensive tools, specifically a festool...

    Last Post By: Justin Rapp Yesterday, 10:58 PM Go to last post
    Malcolm Schweizer

    Share funny pictures here

    Thread Starter: Malcolm Schweizer

    I love these kinds of things. Make me laugh today and share your favorites.

    Last Post By: Jim Koepke Yesterday, 8:11 PM Go to last post
    Patrick Walsh

    1982 Martin T-23

    Thread Starter: Patrick Walsh

    And so it seems it begins again. The T-75 isn’t even technically done and I have a new project. I’m not gonna go all buggy on this one “just yet” if ever. I will 100% go all the way through the machine and make sure it is 100% fully functional to the 9’s. 10’ for me if it was a term. If anything...

    Last Post By: David Kumm Today, 1:02 AM Go to last post
    David Falkner

    CNC - calibration issues for inlay work

    Thread Starter: David Falkner

    This is puzzling to me... I can scribe a line on my spoilboard, move the Y axis 48" by command line, scribe a line there and it measures exactly 48". I can do the same with X and move 25.75" and the measurement appears perfect. I am using a tape measure because that's all I have for measuring...

    Last Post By: David Buchhauser Yesterday, 9:06 PM Go to last post
  • mark mcfarlane

    There is no available content written by mark mcfarlane