They are going crazy building standalone car washes in my area. I know of at least three currently under construction nearby, and a few others that recently opened. Car washes are going up all over the Minneapolis metro area. There will easily be three times as many standalone car washes once...
Last Post By: Brian Elfert Yesterday, 4:24 PMMy landscape guys clean up the beds and install mulch for me now, too old, but I planted everything you see except the very large mature trees. Shade garden, cutting garden, front. Thanks Brian
Last Post By: Brian Runau Today, 1:07 PMHas any one here done one? Looking for suggestions, thanks.
Last Post By: Jerry Bruette Today, 1:23 PMOpinions, please on integrated arbor and chuck for a DP. Am looking at the LLAMBRICH Keyless chucks ... integrated 2MT shank/arbor 1/32" to 3/8" (part# JK10-MT2) 1/32" to 1/2" (JK13-MT2) Thanks
Last Post By: Patty Hann Today, 1:45 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 11:03 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Kiln dried lumber is not an issue with bent lamination. You need 1) laminates that are thin enough to be able to bend around your form, 2) an appropriate
Mike King Today, 3:50 PMI assumed the OP knew this or said table is under complete coverage and only subject to temperature swings. I agree though, it isn't something I'd normally
Michael Burnside Today, 3:44 PMPneumatic pressure is effectively more clamps. And potentially dangerous, as said well above.
Mike King Today, 3:26 PMI’ve had good luck with Peter Galbert’s drawsharp. Benchcrafted sells them, though they are currently out of stock
https://benchcrafted.com/products/dr...42645357625520
I posted on this yesterday, but it is not here.
Best airflow and louver vents are mutually exclusive.
Not too hard to make as
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Mike King Today, 3:50 PM