• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Keith Outten

    Microfence FreeStuff Drawing 9-20-2019

    Thread Starter: Keith Outten

    FreeStuff Drawing Info: Microfence Original Edge-Guide for the router of your choice with their Microfence Stop Collar set. ($249.95 Retail Value) Rich Wedler Phone 818-683-0330 www.microfence.com Drawing will be held on Friday, September 20, 2019

    Last Post By: Rob Charles Today, 2:50 PM Go to last post
    Jamie Buxton

    Cold creep in modified PVA glues?

    Thread Starter: Jamie Buxton

    Ordinary wood glue, for instance Titebond original, is infamous for cold creep. Does anybody know if the modified PVAs like Titebond II or Titebond III creep less?

    Last Post By: Mike King Today, 8:53 PM Go to last post
    Jim Koepke

    Old Molding Planes and the Rehab Enthusiast

    Thread Starter: Jim Koepke

    As is often the case with metal planes, when a wooden body molding plane enters the shop, it is usually in need of some TLC before going to work. Some have expressed interest in knowing more about the process of bringing an old molding plane back to a usable state. I am just a beginner when it...

    Last Post By: Jerry Olexa Today, 8:09 PM Go to last post
    John McKissick

    Midrange Table Saw Advice

    Thread Starter: John McKissick

    Currently using Bosch jobsite saw with gravity rise stand, great tool but need bigger table/rip capacity. 115V and mobility to move in and out of garage over a 1" threshold are limiting factors. Trying to keep price under $2k but the Sawstop may creep over a bit. I have done enough research...

    Last Post By: John McKissick Today, 7:31 AM Go to last post
    Jim Koepke

    Got Some Planing to Do!!!

    Thread Starter: Jim Koepke

    This piece of rough 16/4 poplar was purchased last week. The first step was to get the edges smooth(ish): This was fairly easy to do on a couple of saw benches with a hand screw clamp used as a stop. A #8 plane was used with a light cut. If too heavy of a shaving was being taken the front...

    Last Post By: Jim Koepke Today, 2:12 PM Go to last post
    Greg Parrish

    Sliding Table Saw Jigs ?

    Thread Starter: Greg Parrish

    Iím new to my Felder KF500 and am just now starting to learn working with a slider versus my prior PM66 cabinet saw. other than a fritz and franz jig, and a deflector wedge, are there other jigs for doing things like finger/box joints? Iíve searched and didnít find much but figured there must be a...

    Last Post By: Jim Becker Today, 9:22 AM Go to last post
  • Matt Day

    There is no available content written by Matt Day