So I have a opportunity to purchase the above machine for a fair deal from my employer.
I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement.
So my question is as follows to those in the know with regard to the phenolic ways....
One of my favorite chickens was attacked by a red-tailed hawk today. I heard the commotion and ran up the hill and chased the hawk away.
At first examination it looked like one eye was missing but I think it's OK under an abraded eyelid. There were two places on the chest where skin was...
A hand plane makes a better surface than a planer because it makes one long straight cut vs many short curved cuts. But a planer impacts the wood. Does blade speed also make a difference?
This may sound like a power tool question but I've brought it to the Neandercult because here we think a...
Well, I've seriously looked at my finances and it has reflected that I am not going to be able to pay cash for a Stinger II or even a Stinger I CNC setup. So, I'm now looking at the Shapeoko 3 XXL to allow me to get experience with CNC and enable me to do a few things that I could surely use in my...
So this needs to happen a couple of hundred times. 3/4" bradpoint into endgrain 6" deep. Obviously, friction is my enemy. What options do I have for lubrication/cooling that won't screw with my finishing?
Sections
Recent Articles
Recent Article Comments Widget
Recent Polls
Recent Blog Posts
Vintage Martin T75 restoration
Thread Starter: Patrick WalshSo I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....
Last Post By: Patrick Walsh Today, 6:14 PM