Time for some levity

With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

How to bend wood like this - Outdoor furniture project

Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...

Graule ZS135 Radial Arm Saw voltage question

Recently purchased this Graule at auction in Germany, it went for cheap but import and shipping resolved that bargain aspect pretty quickly. I'm rather unsure of what the voltage is, the tags seem to be giving mixed signals. I wrote the company, but I expect it'll be a while before they provide...

Is there a small, accurate table saw?

I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...

Drill w/guide or router?

Here's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...

Looking for feedback before I buy an Avid CNC

Good day all. I appreciate the time to read and give feedback. I think this is the right machine and price, but want feedback. The time has come. I need a CNC to stay competitive and I also just want to create in new ways. I have “non-buyers remorse” for stopping bidding on a beautiful 5x10...

What's the deal? Jeep rubber ducks.

Sometimes you can really tell when an article was written by AI.

Drill w/guide or router?

If the magnets have center holes for screws I would just use screws, no glue. Much easier to adjust the depth to get it just right. Set them a few thou

Is there a small, accurate table saw?

Thank you to everyone for all the good ideas! I suppose the best saw for the lowest price would be to follow the suggestion to remove the extension table

Glaziers Points Sizes

I think the problem that the OP describes may be that the upright squared wings of the points stick out of the glazing fillet because of the depth of

New Laguna DriftMaster LXIII

I'm wondering if anyone has experience with this new fence. Years ago I bought the original DriftMaster fence, and have struggled with keeping it calibrated...difficult

SC Pig-Picking