• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Bennie Dempsey

    3D Planning Software

    Thread Starter: Bennie Dempsey

    Hey all! I would like to start planning out my projects before I begin them, as I've heard that's a good habit to have. I can find a modeling program online pretty easily, but I wanted to see what you guys use. I am awful at hand drafting so paper and pencil isn't my go-to for personal projects....

    Last Post By: David L Morse Today, 7:00 PM Go to last post
    Larry Frank

    Dust Bin Sensor Completed

    Thread Starter: Larry Frank

    After reading all of the fine work by several members, I decided that I wanted to add the dust bin sensor to my Oneida Super Dust Gorilla. I ordered most of the parts on eBay. The sensor was $3.79, the delay relay board was $4.95 and the 12 V power supply was $9.99. I used some LED trailer...

    Last Post By: Bob Hinden Today, 7:37 PM Go to last post
    Randy Klein

    First Project Finally Complete

    Thread Starter: Randy Klein

    I finally completed my very first project. A twin bed for my son made out of maple and cherry with poplar mattress support slats. The finish is BLO, blonde shellac, and paste wax. It took just under 6 months to do. A lot of that time was spent on researching what tool or technique was needed...

    Last Post By: Jim Barstow Yesterday, 11:43 PM Go to last post
    Michael Gantz

    Hanging EMT conduit in new shop.

    Thread Starter: Michael Gantz

    I'm currently in the process of building a 24' x 36' shop with 10' ceilings. The walls are 2" x 6" studs and the cavities are filled with cellulose insulation. The walls are covered in 1/2" drywall. My intention is to minimize wall penetrations to keep air leaks to a minimum. The plan is to...

    Last Post By: Ron Selzer Today, 12:09 PM Go to last post
    Dave Lehnert

    New Zero Turn Mower

    Thread Starter: Dave Lehnert

    Starting to think about a new Zero Turn Mower. I now own a Toro 52" with a 19 Hp Kawasaki that I have been happy with. Mow 2 1/2 acr all flat. What brand have you been happy with? More important. Is there a brand you have had trouble with? Parts hard to get etc.....

    Last Post By: Ronald Blue Yesterday, 10:52 PM Go to last post
    Greg Parrish

    Folding Table - Which One?

    Thread Starter: Greg Parrish

    Looking for some feedback and input on folding tables like the Festool MFT and Kreg Adaptive System. I would be using this for occasional cuts using my Makita track saw, but on a more regular basis as my sanding surface for my Festool sander/vac and as an assembly/clamping table. i need easy fold...

    Last Post By: ChrisA Edwards Today, 6:14 PM Go to last post
  • Richard Coers

    There is no available content written by Richard Coers