• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Lasse Hilbrandt

    Flattening the sole of a cast steel hand plane?

    Thread Starter: Lasse Hilbrandt

    On YT there are a lot of videos that show how to flatten the sole on hand planes. It seems fairly easy, but I wonder if there are anything that can go wrong if the tecnique is not right? Can one accidently be "rounding" the sole instead because of more gringding at the ends than in the middle of...

    Last Post By: Bruce Haugen Yesterday, 10:32 PM Go to last post
    Keith Outten

    Microfence FreeStuff Drawing 9-20-2019

    Thread Starter: Keith Outten

    FreeStuff Drawing Info: Microfence Original Edge-Guide for the router of your choice with their Microfence Stop Collar set. ($249.95 Retail Value) Rich Wedler Phone 818-683-0330 www.microfence.com Drawing will be held on Friday, September 20, 2019

    Last Post By: Phil Mueller Yesterday, 9:04 PM Go to last post
    Prashun Patel

    Lawn Weeds

    Thread Starter: Prashun Patel

    Does this topic depress you as much as me? Spray, compost, crouch-and-pick. The more time I spend on it, the more they thrive. I have this ONE light green, tall grass that I just can't get rid of. I tried picking them out manually, repeatedly, but they grow back. Does anyone know what this...

    Last Post By: Brian Elfert Yesterday, 11:05 PM Go to last post
    ken hatch

    New Moravian Bench build Part 2

    Thread Starter: ken hatch

    The old thread was getting a little long in tooth. Friday night I screwed up one of the long stretcher tenons. After several rounds of "what if" and "yes but" I made the correct decision and went to the woodstore Saturday and picked up a nice hunk of 12/4 Poplar and started over. Here are...

    Last Post By: ken hatch Yesterday, 11:02 PM Go to last post
    Jeff Duncan

    Tenon tooling for shaper...

    Thread Starter: Jeff Duncan

    So where did you purchase your tenoning tooling from? I have a project that's going to require about 80+ tenons roughly 3/4" thick and up to 3-1/2" long. The length rules out cheating by using my Freeborn cabinet door cutters. I don't see myself getting to deep into doors and windows so not looking...

    Last Post By: Mel Fulks Yesterday, 11:45 PM Go to last post
    andrew whicker

    handheld router with big bit

    Thread Starter: andrew whicker

    Hi all, If I get a custom made router bit for this chamfer and I only take small passes at a time (like 1/16") will handling this router bit be an issue? This is a chamfer on a table top that I don't have room to do with my router table. I am will to change the dimensions some. I think it...

    Last Post By: andrew whicker Yesterday, 8:49 PM Go to last post
  • scott vroom

    There is no available content written by scott vroom