Sawmill Creek Woodworking Community

Sections
Sawmill Creek News

Workshops

Woodturning

Social Woodworking

Tools

Lathes and Accessories

Table Saws and Accessories

Jigs and Fixtures

Cabinetry
Recent Articles
Recent Article Comments Widget
Hottest Threads

Time for some levity
Thread Starter: Dave Anderson NH
With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Ed Aumiller Today, 10:15 AM

A Building Appears
Thread Starter: glenn bradley
My patience is tested by the 2-pics-at-a-time feature so this will be brief.
Last Post By: Rick Potter Today, 2:09 PM

Improved Side Clamping Honing Guide?
Thread Starter: Steve Boring
I've been spending far too much time lately in the sharpening/ honing guide rabbit hole. It seems that the Lie-Nielsen honing guide is great for LN products, but doesn't always accept the geometry found with other manufacturers. The Veritas MK II system seems more versatile, but some people seem...
Last Post By: chuck van dyck Today, 9:28 AM

Powermatic 2820 EVS drill press
Thread Starter: Jordan Lane
Any thoughts on this drill press would be appreciated. I'm in the market for a drill press and this one is appealing to me but appears to be brand new. Thanks
Last Post By: Charles Coolidge Today, 9:26 AM

Rejuvinating The Companionway
Thread Starter: Julie Moriarty
Initially I was thinking of making some new washboards out of tigerwood (goncalo alves) but I decided to see if I could bring the old washboards back to life. The top piece was too far gone so that would be made new. This is how it started First step was replacing the top piece. It...
Last Post By: Mikey Green Yesterday, 4:51 PM

Moving a 1600lbs machine?
Thread Starter: Bryan Hall
So, I am trying to wrap up my machine purchases and the Hammer c3-41 is quite high on the list, but getting it to my home is turning out to be quite the hassle. Hammer can't deliver it to my home if I don't have a forklift, and if I pick it up with a trailer, I'm at a loss for how to move it...
Last Post By: Timothy Orr Yesterday, 9:00 PM

eugene thomas

There is no available content written by eugene thomas

Recent Polls
Do you twist your wires before using a wire nut? (Votes: 48)

Yes (Votes: 36)

No (Votes: 12)
Recent Forum Posts

A Building Appears

Alan's post reminds me...

We have 8' skylights on my workshop on the North side, where the sun never hits directly, and I recommend them
Rick Potter Today, 2:09 PM

Looking for ideas on making some trim

You're right there, that's the only remaining debate in my mind, as the router bit in my "regular" vertical table makes running the board
Dave Mills Today, 2:09 PM

Woodmaster Drum Sander

I haven’t used it on anything as large as your drum but Goof Off works well at removing adhesive. Safety precautions (gloves, eye protection, ventilation)
Bruce Page Today, 2:03 PM

FS: Bridge City HG-4 Honing Guide and Veritas 2" PM-V11 Stanley Blade and Cap Iron

Tim, Responded.
Mike Tekin Today, 1:58 PM

Woodmaster Drum Sander

Goo gone in the metal can squirt a little on small sections allow it to sit and use plastic putty knife to scrape took about an hour but drum was clean
Gary roebuck Today, 1:53 PM
Recent Blog Posts

Sections

Recent Articles

Recent Article Comments Widget

Hottest Threads

eugene thomas

Recent Polls

Recent Forum Posts

Recent Blog Posts