• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Allen Today, 6:32 PM Go to last post
    Bryan Hall

    Sawstop ICS Problems and Support

    Thread Starter: Bryan Hall

    Disclaimer: I want to be up front with the fact that this is going to be a less than favorable view on Sawstop. However, my intent is not to go ranting on the forums about Sawstop being a terrible company. I have a very significant issue with my brand new saw, and I'm sharing this mainly due to...

    Last Post By: Ronald Blue Today, 1:12 PM Go to last post
    Jacob Mac

    Hammer K3 Winner 48x48 thoughts?

    Thread Starter: Jacob Mac

    I'm kicking around getting the Hammer K3 Winner 48x48 sliding table saw. Does anyone have one? Experience with it? Better options in the $5,000 price range? I suppose the Sawstop and the Minimax SC2 are probably the other contenders. I'm tracking that used is always an option, just tough to...

    Last Post By: Michael Drew Yesterday, 10:25 PM Go to last post
    derek labian

    Advice on sagging Jointer table (MM FS41ES)

    Thread Starter: derek labian

    I have a sagging jointer in-feed table table that is producing concave joints (cup in the middle). This is a new MM FS41ES so this has been happening since production. Since I assumed it was factory adjusted, I thought it was my technic but its clear now its the in-feed table. Just incase anyone is...

    Last Post By: mreza Salav Today, 12:42 PM Go to last post
    derek labian

    Mitutoyo Dial Indicators Recommenation

    Thread Starter: derek labian

    I currently have a digital dial indicator with resolution of .001. I was thinking about going to an analog and a better indicator. Batteries are always dying and analog just seems easier to use. I was looking at the Mitutoyo indicators. My application will be jointer/shaper tooling setup...

    Last Post By: Charles Coolidge Today, 6:49 PM Go to last post
    Jerry Olexa

    Best sealer/protection for Workbench top

    Thread Starter: Jerry Olexa

    I know there are many opinions on this but..... I'm in process of flattening my workbench top ...I've heard many opinions on the best top coat for this from oil, wax, mixtures, BLO, wax only etc etc... What is YOUR opinion on the best way to protect, seal, finish, preserve wooden WORKBENCH...

    Last Post By: Jim Becker Today, 4:30 PM Go to last post
  • Mike Henderson

    There is no available content written by Mike Henderson