Hey everyone I have a nice router table, but I've been thinking of upgrading to a shaper. I'm thinking 5hp would be ideal, but I'm not sure what other features exactly I should be looking for. There are 3 that seem like a good fit and I'm hoping to get some feedback based on their specs and/or...
Last Post By: Patrick Kane Today, 10:37 AMMy son Miles is in Normandy until August working on a crew fabricating trusses and other elements for the nave and choir of the cathedral. He is one of a half dozen American timber framers working on the project, which is being undertaken by two French companies https://www.remy-desmonts.com/ and...
Last Post By: Kevin Jenness Today, 12:15 PMI just read that Virginia requires safe storage. I have my dads 22ga rifle that he had when he was a kid. I don’t know exactly when he got it but it’s pretty old. He was born in 1908. the gun breaks down into two pieces and is stored in some sort of long sock that’s supposed to prevent rust....
Last Post By: James Tibbetts Today, 12:01 PMI had the high bid tonight on this Rockwell/Delta 28-350. I've been looking for and bidding on these for the last few years, and I was the back bidder a few times, but this one went for a very good price. My reserve bid was $600. It's possible that there's something terribly wrong with it, but...
Last Post By: Zachary Hoyt Today, 12:41 PMI've talked about this several times and I'm finally back to building #2! When I built my first guitar I didn't have the CNC, actually built the CNC while I was finishing that guitar so the only job I did on the CNC for that guitar was a little bit of the bridge. I began build #2 while I was...
Last Post By: David Falkner Today, 4:23 PMSoda Pop (Votes: 1)
Soda (Votes: 19)
Pop (Votes: 19)
Coke (Votes: 5)
Cola (Votes: 0)
Soft Drink (Votes: 7)
Cold Drink (Votes: 1)
Tonic (Votes: 0)
None of the above (Votes: 6)
Shane
I just had a mylar job yesterday and cut 10 mill mylar to the required shape and cutouts. I did it all in vector mode with my 80 watt Trotec.
Second "cheap" plane this week...$19 for a #3 sized smoother..
It was the "pick of the 7 plane litter"
Before I’d guess it is a bad thermal overload device, I’d look pretty carefully at the power cord and the connectors on both ends. In general, connectors
Jamie Buxton Today, 5:49 PMI grew up in a Miracle Whip household. When I met my wife (to be) and her kids, they were set on Hellman's mayonnaise. Thought I was going to be burned
Monte Milanuk Today, 5:18 PMI assume this planer was made and sold under different names by someone else. look for those manuals.
Bill D
Are your tools dangerous?
Thread Starter: Edward WeberDo you consider tools as dangerous? https://www.popularmechanics.com/home/tools/how-to/g2394/10-workshop-tools-that-can-kill-you/ I came accross this article and it struck me, that I don't consider my tools as dangerous or not. To me it's just a tool. Sure, some tools can cause greater injury...
Last Post By: Ron Citerone Yesterday, 8:32 PM