• Jim Andrew

    There is no available content written by Jim Andrew
  • Recent Polls

  • Recent Forum Posts

    Jim Becker

    Cutter Choices

    95+% of my tooling is two-flute. I have one size of really small cutter (.022") for guitar fretboards that is three flute and a few one flute cutters

    Jim Becker Today, 11:23 PM Go to last post
    johnny means

    20 Disk Sander Dust Collection

    Replace that dinky dust collection fitting with a 4" round to rectangle fitting (6" would be better). You could probably find something close

    johnny means Today, 11:21 PM Go to last post
    tom lucas

    EZ Sphere Question

    I'm considering buying the chefwarekits EZ Sphere jig. I have a Grizzly G0766, which ideally requires an 8 3/4" post. The jig comes with an 8"

    tom lucas Today, 11:16 PM Go to last post
    Jim Becker

    Domino for Doors

    Dom, I personally wouldn't be concerned with using 14mm sipo Dominos for exterior doors in lieu of traditional tenons...which also depend upon the glue.

    Jim Becker Today, 11:14 PM Go to last post
    Ronald Blue

    Cutter Choices

    Thanks for the replies on this. I will use the chart and experiment. Find the feed rates that give the best results.

    Ronald Blue Today, 11:12 PM Go to last post
  • Recent Blog Posts