• Mike Chance in Iowa

    There is no available content written by Mike Chance in Iowa
  • Recent Polls

  • Recent Forum Posts

    William Fretwell

    Show us your sharpening stations

    I wanted some weight at the top of the sharpening station so it would not move around. A black granite off cut from a kitchen counter place works well.

    William Fretwell Today, 7:20 AM Go to last post
    Ken Krawford

    Filling Mahogany Grain

    Interesting product. This is the second pair of mahogany doors I have done in the last six months and I hope the last for a while. With the benefit

    Ken Krawford Today, 6:06 AM Go to last post
    Chris Parks

    Hammer K3 Blade Lift Problem

    A thread dredge for those interested. I have finally resolved this problem properly and as I mentioned earlier it all resolves around the support block

    Chris Parks Today, 4:34 AM Go to last post
    Oskar Sedell

    Show us your sharpening stations

    A simple shelf, at good standing height for me. Small wooden tray with a bridge collects sharpening smudge and flattening slurry which dries in the tray

    Oskar Sedell Today, 2:53 AM Go to last post
    Rod Wolfy

    SMC Minimax and Felder Questions

    I don't know what you're planning, but I'd go with 2 machines, if given the choice. I had an older Felder 4 in 1. I liked the compactness, but I didn't

    Rod Wolfy Today, 2:46 AM Go to last post
  • Recent Blog Posts