Hi all, I don't look often, but when I do it seems there are absolutely no used mortising machines out there. Something I've always wanted (someday) was a knee mill. There's a place near me that has had a Cincinnati Contour Master for sale forever (years and years). They re build these...
Last Post By: Joe Calhoon Today, 10:13 AMGreetings All, I’ve done a search here, but all the threads I have seen are old. I would like a recommendation for an adhesive with a long open time for complicated glue ups, minimum 30 minutes,. I typically use Titebond 3 but would like more time for some projects. Sometimes it’s possible to do...
Last Post By: Jimmy Harris Today, 9:48 AMI recently sold a machine I didn't need and now can repurpose that money into something else. I recently got a Sawstop and was thinking of the Harvey sliding table attachment for it. Expensive but it sure looks like the build quality is first class. You essentially get the Harvey miter gauge as...
Last Post By: Michael Burnside Today, 3:27 PMI have two exterior doors, one to the back of my house and one to my tool shed. Both are showing the effects of winter water splashing up on them at the base. The door to my shed is really bad. I don't want to replace the doors but would like to put a board over the base, like a kickplate to...
Last Post By: Patrick Curry Today, 5:36 AMWe’re gluing old chairs that have come a little loose. Any tips on how to get Titebond in a small crack? Will thinning make it useless? Thank you.
Last Post By: Rafael Herrera Today, 10:34 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Aaron said it should work but has not been tested on CorelDraw 2023.
Jackie Outten Today, 7:44 PMThe OP is not going to be able to answer you as this thread is from 2010 and they are no longer a member of the SMC community. Bill's and Edward's advice
Jim Becker Today, 7:40 PMYes, you are missing the "+Post New Thread" button near the top, left of any forum discussion area.
Jim Becker Today, 7:37 PMLosing the weight is an issue for our daughter because of the medications she's on for her disability. Not getting the knee replacement would have meant
Jim Becker Today, 7:29 PMDepending on where on your construction (if they'll be seen), stainless "staples" are less prone to puling out.
Edward Weber Today, 6:49 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 4:39 PM