Sawmill Creek Woodworking Community

Sections
Sawmill Creek News

Workshops

Woodturning

Social Woodworking

Tools

Lathes and Accessories

Table Saws and Accessories

Jigs and Fixtures

Cabinetry
Recent Articles
Recent Article Comments Widget
Hottest Threads

Time for some levity
Thread Starter: Dave Anderson NH
With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Mike Soaper Today, 10:30 PM

New solid body electric guitar
Thread Starter: roger wiegand
I hope to make periodic posts through this build, the Day designations will, I expect refer to days of posts rather than day of build, perhaps like some people interpret biblical "days" of creation. Too many other projects happening at the same time! I built a bass with my son most of a decade ago,...
Last Post By: David Falkner Today, 8:32 AM

Any chance of construction lumber prices going down in six months?
Thread Starter: Bill Dufour
Lumber is about 100% higher with covid since 12 months ago. More homes are starting to be built. Any thoughts on construction lumber prices in the next 12 months? Bill D
Last Post By: William Bell Today, 9:38 PM

A Building Appears
Thread Starter: glenn bradley
My patience is tested by the 2-pics-at-a-time feature so this will be brief.
Last Post By: Bill Carey Today, 11:20 AM

Vaccination Arm
Thread Starter: Tom Bender
Don't get your Covid Vaccination in your toilet paper arm.
Last Post By: Lee DeRaud Today, 7:32 PM

Track Saw vs Circular Saw vs Table saw Vs Miter saw - Which one to start with?
Thread Starter: Amelia Green
Hi, I realise that all tools are not equal. I remember someone saying that even a table saw does not equal a table saw does not equal a table saw :eek: But if someone is just getting into the woodworking hobby with a limited space available for the workshop, which one would you guys recommend...
Last Post By: Alex Zeller Today, 12:52 PM

Paul McGaha

There is no available content written by Paul McGaha

Recent Polls
Do you twist your wires before using a wire nut? (Votes: 48)

Yes (Votes: 36)

No (Votes: 12)
Recent Forum Posts

1/8" Glass in 1/4" Groove - Kitchen Cabinet Doors

+1 to Richard's opinion. Always a rabbet, never a groove or dado. I use 1/4 x 1/4" lengths of wood (same species and finish) and pin nail these
Thomas McCurnin Today, 10:51 PM

Time for some levity

I saw a unique store/shop? today

"Rudy's welding service and cold beer"
Mike Soaper Today, 10:30 PM

Grain orientation wedged round M&T

Mark, wood is elastic, you don’t go from ‘snugging up the joint’ to destroying the cells, there is an elastic compression first. If there was not then
William Fretwell Today, 10:25 PM

Delta vs Jet

I have no confidence in anything from Delta since the latest owner took over. Jet would be the answer to your question with me.
Richard Coers Today, 10:25 PM

1/8" Glass in 1/4" Groove - Kitchen Cabinet Doors

I've never fit glass into a groove, always put it in a rabbet with a quarter round. Put it in a groove and it cracks or breaks and you have no way to
Richard Coers Today, 10:19 PM
Recent Blog Posts

Sections

Recent Articles

Recent Article Comments Widget

Hottest Threads

Paul McGaha

Recent Polls

Recent Forum Posts

Recent Blog Posts