• Recent Polls

  • Recent Forum Posts

    Shiraz Balolia

    New Grizzly G0868 Jointer

    No, this one is more accurate and Made in Taiwan by a ISO 9001 factory that we have dealt with since inception (35 years ago).

    Build quality

    Shiraz Balolia Today, 1:09 PM Go to last post
    Jim Becker

    Trestle Legs

    The lamination method you propose is exactly the same way I've built a door and it greatly simplifies the deep mortise challenge.

    Jim Becker Today, 1:06 PM Go to last post
    Matt Mattingley

    Shaper head on table saw

    Joe, you got it. When the motor bumps the bottom of the table with an 18 inch blade, I’m getting 5 inch depth of cut. A 10” dia would be min.

    Matt Mattingley Today, 1:06 PM Go to last post
    John K Jordan

    something smells like cherry

    Sounds like turning wood to me! Slabs if wide enough. The triple crotch may be spectacular if in good condition. I've sawn good lumber from large

    John K Jordan Today, 1:05 PM Go to last post
    Peter Kelly

    Heat a 12x20 shop with wood?

    Either the Farenheat or Reznor overhead electric heaters are good. I installed a 7,500 watt one at the 14' x 20' shop in PA and it's more than adequate.

    Peter Kelly Today, 1:04 PM Go to last post
  • Recent Blog Posts