I'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: Alex Zeller Today, 1:54 PMHello, I’m looking for advice and recommendations for a good plan or kit to construct a sailboat for a novice crew. My 10yo daughter went to sailing camp last summer and had a blast. It was a skills based camp that eventually leads to racing and ASA certification. They used what appeared to...
Last Post By: Maurice Mcmurry Today, 4:36 PMThis morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...
Last Post By: Jim Becker Today, 10:02 AMA friend recently asked me to make her a cremation ashes box (for herself). I did some research and the recommendation is one cubic inch per pound of body weight. All fine. But then she suggested that we make it as something she can use while alive. I thought of a jewelry box but I know...
Last Post By: Tim Greif Today, 2:04 PMIn an attempt to eliminate carrying table extensions up and down the stairs, I am building a butterfly extension dining table. It's my first attempt at a dining table. My wife and I looked at different dining tables and she wanted a 4-leg table base. I bought a geared table extension mechanism from...
Last Post By: Ken Fitzgerald Today, 3:29 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Go back and look at the caul and padding photo from Michael Fortune I posted. If you make a similar caul, use sufficient flexible padding, and increase
Mike King Today, 6:28 PMPriced reduced; $25 Shipped.
thanks for looking.
My experience is that *it depends* and that it can be a difficult profession to find balance and financial success in.
It depends on so many
Neat-O! I love the 3 leg chair
Maurice Mcmurry Today, 6:12 PMIts fun to get a peek inside your shop! Keep up the good work. Don't forget to surf (at least a little).
Maurice Mcmurry Today, 6:02 PM
How to bend wood like this - Outdoor furniture project
Thread Starter: Alan LightstoneLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Alan Lightstone Today, 3:50 PM