Hi all, I don't look often, but when I do it seems there are absolutely no used mortising machines out there. Something I've always wanted (someday) was a knee mill. There's a place near me that has had a Cincinnati Contour Master for sale forever (years and years). They re build these...
Last Post By: Wes Grass Today, 1:49 AMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 9:57 AMAbout a year ago I was reading and found that Vietnam veterans qualified for VA medical benefits. About the same time, I was talking with a neighbor who came over to ask me about hearing aids. I have bimodal hearing; I have a cochlear implant (CI) on one ear and a hearing aid (Ha)on the other ear...
Last Post By: Mike Henderson Today, 11:09 AMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Tom M King Today, 9:43 PMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Today, 10:37 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Thank you for explaining.
I'll probably us 6 coats of thinned (50/50) varathane for the work surfaces and 3 coats of same for the vertical surfaces.
Got lucky and saw Frank Zappa in Arlington, Tx 1971 or 72. He had about 10 or 12 musicians with him including some of the Mothers along with a few people
Jay Bryant Today, 11:16 PMPatty, when I first began using Min-Wax fast drying poly years ago, I had to thin it. Then I noticed it seemed to be thinner than previously. I began
Ken Fitzgerald Today, 11:09 PMAre you sure there wasn't any fuel contamination of any kind?
jtk
This arrived today and was applied to my grip ring (knob). It took a little quick work with a pair of scissors and all is well.
Looks like
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 12:22 PM