• Maurice Mcmurry

    There is no available content written by Maurice Mcmurry
  • Recent Polls

  • Recent Forum Posts

    Malcolm McLeod

    Gassed up today

    Didn't have to purchase - riding in Uber - so I could just gasp and point.

    Malcolm McLeod Today, 12:21 PM Go to last post
    Larry Frank

    Dust collector air flow measurements

    If you want to use the fan anemometer, then use it. In large ducts like HVAC it is fine. But, with small ducts there are issues with turbulence that

    Larry Frank Today, 12:19 PM Go to last post
    Bruce Jones

    Tear Drop WIP

    “Can we stop all the tears”
    This piece is composed of art 101 shapes: cylinder, sphere and cone. The teardrop shape is very close to the cone shape.

    Bruce Jones Today, 12:17 PM Go to last post
    Ray Newman

    Sawstop sliding table

    Agree with Kevin Jenness. I ran a Uni-saw from 1987-2016 and at one time I had the Excalibur table on it. Took it off as I was not satisfied with it.

    Ray Newman Today, 12:16 PM Go to last post
    Lee DeRaud

    Gassed up today

    So, $6.89 in SB? Ouch. You should have stopped sooner: we're only about $6.10 or so 150mi south...I suspect Ventura would have been about the same.

    Lee DeRaud Today, 12:15 PM Go to last post
  • Recent Blog Posts