• Jim Koepke

    There is no available content written by Jim Koepke
  • Recent Polls

  • Recent Forum Posts

    David Jirak

    Dados in hundreds of parts

    I am manufacturing a product for my wife's quilt shop business. The base of which is 1/2" baltic birch that is 3" wide by either 12"

    David Jirak Today, 12:15 AM Go to last post
    John K Jordan

    The best I've seen

    The best solution I've seen is the vacuum gasket tape that Joe Woodworker (Joe Gorleski) sells. This stuff is made for vacuum chucking and clamping use.

    John K Jordan Today, 12:14 AM Go to last post
    Mike Henderson

    Value of chair corner braces?

    When repairing a chair you really need to disassemble it, fix the joints (maybe put loose tenons in the back) and re-glue. The good thing about that

    Mike Henderson Today, 12:13 AM Go to last post
    Misty Smith

    Exhaust System

    I have a mini24. There are 2 air ports at the bottom of the cabinet. I always assumed the blower would pull air from above and below the honeycomb. I

    Misty Smith Today, 12:08 AM Go to last post
    Brian Holcombe

    Vintage Martin T75 restoration

    Most often the bearings have the number right on the side of them. I type that into McMaster and it will populate the sizing, from there I will chose

    Brian Holcombe Today, 12:06 AM Go to last post
  • Recent Blog Posts