• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Dave Anderson NH Today, 12:41 PM Go to last post
    Phil Mueller

    Made in China sentiment

    Thread Starter: Phil Mueller

    As a retail small business owner, selling a number of high quality made in China products, Iím curious of any changes in consumer sentiment. Given the current pandemic, will made in China products be more of a deal breaker, or the same? Obviously, if you avoided made in China in the past, you...

    Last Post By: Doug Dawson Yesterday, 7:01 PM Go to last post
    Steve Mathews

    Installing ductwork for dust collector? Pics

    Thread Starter: Steve Mathews

    I just ordered most of the ducts and fittings for my dust collection system. A few questions remain for the install that I'm hoping to resolve here. Photos are included below to give some sense of what I'm trying to accomplish. The first photo below shows a rough sketch of the layout. Along the...

    Last Post By: Thomas Crawford Today, 3:17 PM Go to last post
    Kenny Southerland

    Table Saw Not cutting 90* (HELP!)

    Thread Starter: Kenny Southerland

    I am having a problem with my table saw that is about to make me lose my mind (up in here, up in here). I am about to finish my first year of woodworking. I have a 90s model craftsman table saw that I have had for about 9 months. It is the 315.228390, essentially the same thing as...

    Last Post By: Myk Rian Today, 11:57 AM Go to last post
    Dan Gaylin

    Forstner bit problems

    Thread Starter: Dan Gaylin

    So I was doing the rare bit of spindle work (I mostly do bowls) and I was trying to get a 1 3/4” diameter recess for a candle in a cherry candlestick I had turned. I put my 2 MT drill chuck in the tail stock and put a 1 3/4” forstner bit into the chuck. Set my lathe to its lowest speed. Brought...

    Last Post By: John K Jordan Today, 9:14 AM Go to last post
    Derek Cohen

    Marking knives for joinery

    Thread Starter: Derek Cohen

    These are some the knives I have collected over the years and use for laying out joinery. Obviously not all at the same time :) Three popular knives - these ones get a lot of use. From the top down ... Swann-Morton fixed blade, Stanley swivel blade, and a Swann-Morton craft knife which was my...

    Last Post By: mike stenson Today, 10:52 AM Go to last post
  • Darrell Friesen

    There is no available content written by Darrell Friesen