• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Keith Outten

    Microfence FreeStuff Drawing 9-20-2019

    Thread Starter: Keith Outten

    FreeStuff Drawing Info: Microfence Original Edge-Guide for the router of your choice with their Microfence Stop Collar set. ($249.95 Retail Value) Rich Wedler Phone 818-683-0330 www.microfence.com Drawing will be held on Friday, September 20, 2019

    Last Post By: Rick Brantley Today, 7:51 AM Go to last post
    Dan Friedrichs

    "Professional" paint (Sherwin Williams, etc) vs Box-Store paint

    Thread Starter: Dan Friedrichs

    In our new house, I bought Valspar Signature paint from Lowe's to paint the entire interior, but ended up hiring professional painters to do the job. Nice, honest guys, who very timidly pulled me aside after putting on 2 coats of the Valspar and asked if I'd be offended if they went and bought...

    Last Post By: Darcy Warner Yesterday, 11:43 AM Go to last post
    John McKissick

    Midrange Table Saw Advice

    Thread Starter: John McKissick

    Currently using Bosch jobsite saw with gravity rise stand, great tool but need bigger table/rip capacity. 115V and mobility to move in and out of garage over a 1" threshold are limiting factors. Trying to keep price under $2k but the Sawstop may creep over a bit. I have done enough research...

    Last Post By: John McKissick Today, 7:31 AM Go to last post
    Jim Koepke

    Got Some Planing to Do!!!

    Thread Starter: Jim Koepke

    This piece of rough 16/4 poplar was purchased last week. The first step was to get the edges smooth(ish): This was fairly easy to do on a couple of saw benches with a hand screw clamp used as a stop. A #8 plane was used with a light cut. If too heavy of a shaving was being taken the front...

    Last Post By: Charles Heaps Today, 8:48 AM Go to last post
    Greg Parrish

    Sliding Table Saw Jigs ?

    Thread Starter: Greg Parrish

    Iím new to my Felder KF500 and am just now starting to learn working with a slider versus my prior PM66 cabinet saw. other than a fritz and franz jig, and a deflector wedge, are there other jigs for doing things like finger/box joints? Iíve searched and didnít find much but figured there must be a...

    Last Post By: Jim Becker Today, 9:22 AM Go to last post
    John TenEyck

    Finished my Solar Lumber Drier Today

    Thread Starter: John TenEyck

    Now that I own a bandsaw lumber mill I need to be able to dry wood a lot more efficiently and hopefully with better control than air drying it in stacks. So I built a solar lumber drier. The design is very similar to one published in Wood Magazine several years ago. It has an 8 x 12' footprint,...

    Last Post By: Scott T Smith Yesterday, 4:21 PM Go to last post
  • Anthony S Martin

    There is no available content written by Anthony S Martin