• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Erik Loza

    Some Euro machines in local shops...

    Thread Starter: Erik Loza

    I recently did a tour of a few local Austin shops. Typically, what I see in shops is a bunch of either older American iron or your typical Chaiwanese assortment of table saws, jointers, planers, etc. I'll post pics from our shop at some point but I thought folks might enjoy seeing some Euro...

    Last Post By: Erik Loza Today, 9:42 AM Go to last post
    Jamie Buxton

    Cold creep in modified PVA glues?

    Thread Starter: Jamie Buxton

    Ordinary wood glue, for instance Titebond original, is infamous for cold creep. Does anybody know if the modified PVAs like Titebond II or Titebond III creep less?

    Last Post By: Mel Fulks Today, 7:04 PM Go to last post
    John McGovern

    Table Saw Questions

    Thread Starter: John McGovern

    Hi All, I've been lurking in the weeds for some time and have found this venue to be the most knowledgeable, helpful, and courteous forum on the block. And, I know this question has been asked and answered so many times, but I hope you all have the patience for one more dip to the well to answer...

    Last Post By: Alan Lightstone Today, 10:19 AM Go to last post
    Paul F Franklin

    New Lee Valley Web Site

    Thread Starter: Paul F Franklin

    Seems the roll out of the new site is not going completely smoothly. Have been trying to place an order all morning and the site just spins when I try to checkout. Tried a few different browsers too. Guess I may have to call :eek: New site design seems nice and clean though but it will take...

    Last Post By: ChrisA Edwards Today, 10:39 PM Go to last post
    Carl Beckett

    Tablesaw dust collection hood

    Thread Starter: Carl Beckett

    Well, after a weekend working with black walnut I have GOT to improve my tablesaw dust collection. Which means time to put the blade guard/collection hood at the top of the project list. The support arm will be home made. The guard/hood can be either home made or purchased, but since I want to...

    Last Post By: Carl Beckett Today, 12:22 PM Go to last post
    Steven J Corpstein

    Threaded inserts for hardwood

    Thread Starter: Steven J Corpstein

    What do you use for threaded inserts when you're putting them in hardwood? I've always used the brass ones in the past, but they are a bear to get in straight and sometimes lift the grain. I'm countersinking the hole but they still give me fits.

    Last Post By: Corey Pelton Today, 6:56 PM Go to last post
  • Mark Hockenberg

    There is no available content written by Mark Hockenberg