• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 6:14 PM Go to last post
    John K Jordan

    Hawk and chicken

    Thread Starter: John K Jordan

    One of my favorite chickens was attacked by a red-tailed hawk today. I heard the commotion and ran up the hill and chased the hawk away. At first examination it looked like one eye was missing but I think it's OK under an abraded eyelid. There were two places on the chest where skin was...

    Last Post By: Tom M King Yesterday, 7:31 PM Go to last post
    Tom Bender

    Handplane vs Lunchbox

    Thread Starter: Tom Bender

    A hand plane makes a better surface than a planer because it makes one long straight cut vs many short curved cuts. But a planer impacts the wood. Does blade speed also make a difference? This may sound like a power tool question but I've brought it to the Neandercult because here we think a...

    Last Post By: Jim Koepke Today, 2:51 AM Go to last post
    Malcolm Schweizer

    Share funny pictures here

    Thread Starter: Malcolm Schweizer

    I love these kinds of things. Make me laugh today and share your favorites.

    Last Post By: Jim Koepke Yesterday, 8:43 PM Go to last post
    Dennis Peacock

    Shapeoko - XXL - Anybody running one?

    Thread Starter: Dennis Peacock

    Well, I've seriously looked at my finances and it has reflected that I am not going to be able to pay cash for a Stinger II or even a Stinger I CNC setup. So, I'm now looking at the Shapeoko 3 XXL to allow me to get experience with CNC and enable me to do a few things that I could surely use in my...

    Last Post By: David Buchhauser Yesterday, 10:57 PM Go to last post
    Bob Jones 5443

    Considering a router lift

    Thread Starter: Bob Jones 5443

    I have a Porter Cable 690 in my router table now. I like it: it's variable speed, which seems hard to find with the 690 these days. It's on a 9" x 12" Rousseau phenolic plate, and I can make do with it have for a decade. There are times, however, when it's a royal pain to back off a precise...

    Last Post By: Bob Jones 5443 Today, 2:04 AM Go to last post
  • Clark Hussey

    There is no available content written by Clark Hussey