• Andrew More

    There is no available content written by Andrew More
  • Recent Polls

    Leave the drill bit in the drill, or not (Votes: 12)

    1. in the drill/brace (Votes: 1)

    2. take out, place in a box/rack (Votes: 11)

  • Recent Forum Posts

    Darcy Warner

    What cost COVID-19?

    [QUOTE=Kev Williams;3008861]Re: those politicians with inside knowledge buying and selling stocks-- illegal? Unethical? What about this below? --note

    Darcy Warner Today, 12:40 AM Go to last post
    Ken Fitzgerald

    John Prine

    I discovered John Prine's music some 20 years ago. Some of his folks songs are haunting, IMO. RIP.

    Ken Fitzgerald Today, 12:31 AM Go to last post
    Wes Grass

    Tips for jointing longer boards

    I did some 7' pieces today, that had been ripped (bandsaw) from 10" wide planks. On one of them, the kerf had opened up to about 1/4" after

    Wes Grass Today, 12:30 AM Go to last post
    Bob Glenn

    Travisher?

    Plus one on Galbert's design. Additionally, you can touch up the cutting edge without removing the iron from the tool.

    Bob Glenn Today, 12:27 AM Go to last post
    Bob Glenn

    Chipped plane blade

    Okay, here is what I did. This iron was probably quenched but never tempered. More that likely, due to its age, the smith probably laminated the tool

    Bob Glenn Today, 12:25 AM Go to last post
  • Recent Blog Posts