• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Today, 9:30 PM Go to last post
    Jon Snider

    New shop build, the MBS

    Thread Starter: Jon Snider

    I’ve received some offline encouragement to post some content of my new shop build. If you’ve read any of my other numerous questions (thx all for invaluable help), I’ve been at this since last April. Here is an effort to slowly catch up. The shop replaces the same spot where I built a veggie...

    Last Post By: Jay Champagne Today, 6:49 AM Go to last post
    Thomas Crawford

    restoring a powermatic 15HH

    Thread Starter: Thomas Crawford

    So this thing followed me home finally last week. Its a bit of a mess but I'm hoping I can get it all cleaned up.

    Last Post By: Thomas Crawford Today, 11:44 AM Go to last post
    mark mcfarlane

    Air compressor blowing circuit breaker

    Thread Starter: mark mcfarlane

    I have a slow leak somewhere in my air line plumbing (which I possibly should not have installed in the walls...), This causes my air compressor to cycle maybe once or twice a day to refill the circular network of air lines. Every few days the compressor throws the 20 amp dedicated 120V circuit...

    Last Post By: Edward Dyas Today, 9:28 PM Go to last post
    Mark Blatter

    Shop Heat

    Thread Starter: Mark Blatter

    I started my shop a little over two years ago. I had it mostly completed by June or so of last year, but was busy and just didn't the heating system completed. All last winter I used a space heater, burning through I don't know how many tanks of propane. All the time, the on-demand water heater...

    Last Post By: sean meltvedt Today, 4:50 PM Go to last post
    ken hatch

    Time To Eat Crow

    Thread Starter: ken hatch

    For years I've had a thing about tail vises, end vises, wagon vises, for that matter anything that hangs off or works from the right end of my right handed bench. I've thought they were not worth the time or money to install. That there were better ways to do the same job from a...

    Last Post By: Jim Koepke Today, 4:48 PM Go to last post
  • Kevin Mibb

    There is no available content written by Kevin Mibb