Sawmill Creek Woodworking Community

Sections
Sawmill Creek News

Workshops

Woodturning

Social Woodworking

Tools

Lathes and Accessories

Table Saws and Accessories

Jigs and Fixtures

Cabinetry
Recent Articles
Recent Article Comments Widget
Hottest Threads

Time for some levity
Thread Starter: Dave Anderson NH
With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: John Ziebron Today, 10:58 AM

Krenov Style Apron Plane
Thread Starter: Dale Osowski
Attention to my woodworking friends! I have a fair amount of Gaboon Ebony cutoffs I've collected over the years and I'm looking to put them to good use. I'm thinking about making a number of small Krenov style apron / block planes that would be available for sale. They would be made of Gaboon...
Last Post By: Dale Osowski Today, 10:38 AM

Cost effectiveness of a slider vs. tracksaw & tablesaw
Thread Starter: Jonathan Jung
I thought about posting this to the business section, because I'd really like input from professionals who use their shop as a business. For those of you who make $ or even a living making furniture or cabinets, how long does it take for a sliding table saw to pay for itself compared to a track saw...
Last Post By: Ronald Blue Today, 9:20 AM

Solid Walnut bookshelf dados - is glue enough?
Thread Starter: Bill Brammer
Building 6 ft high, 28 in wide, 12 inch deep solid 3/4 inch walnut bookshelf , no adjustable shelves. I have dados for all shelves. The sides are a little bowed, requiring some pressure with clamps to pull them together with the dados. Not a ton, but some. I'm trying to decide if I need to add...
Last Post By: Bill Brammer Today, 12:03 PM

Lift lock and roll
Thread Starter: Gregg Feldstone
I wish I had bought the lift lock and roll mobility device which apparently is not made anymore. Does anyone know where I could get one or have one to sell? I need it for my PM 3520 B
Last Post By: Roger Chandler Today, 10:30 AM

Options for Harvey Table Saw?
Thread Starter: Pat Germain
I've been away from woodworking for about ten years while I was restoring a car. It was something wanted to do since I was a kid and I finally got it done. Now I want to get back into woodworking and I will need a new table saw. I had been using a hot-rodded Craftsman contractor saw. It got the...
Last Post By: Pat Germain Today, 10:26 AM

Paul F Franklin

There is no available content written by Paul F Franklin

Recent Polls
Recent Forum Posts

Snap lock versus spiral duct

If money were no object I'd certainly have the spiral, but alas...

That said, in my 30x30 ft shop with a 7" main line that picks up
roger wiegand Today, 12:54 PM

FS - Oneway Wolverine Grinding Jig Components

PM reply sent
robert mcmanus Today, 12:53 PM

FS - Osborne Excalibur miter gauge - LIKE NEW NEVER USED! Northcentral Indiana

Sent PM with questions
Lance Mirrer Today, 12:29 PM

Best wax

Hi folks. I have a stereo rack that is finished in lacquer. I will be putting heavy audio equipment on it and the components will have rubber and sorbothane
Dan Gaylin Today, 12:16 PM

Solid Walnut bookshelf dados - is glue enough?

Shims! Much easier than making and storing bowed cauls.. Thank you
Bill Brammer Today, 12:03 PM
Recent Blog Posts

Sections

Recent Articles

Recent Article Comments Widget

Hottest Threads

Paul F Franklin

Recent Polls

Recent Forum Posts

Recent Blog Posts