• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Paul F Franklin Yesterday, 9:50 PM Go to last post
    Bryan Hall

    Sawstop ICS Problems and Support

    Thread Starter: Bryan Hall

    Disclaimer: I want to be up front with the fact that this is going to be a less than favorable view on Sawstop. However, my intent is not to go ranting on the forums about Sawstop being a terrible company. I have a very significant issue with my brand new saw, and I'm sharing this mainly due to...

    Last Post By: Frank Pratt Yesterday, 12:08 PM Go to last post
    Larry Frank

    Dust Bin Sensor Completed

    Thread Starter: Larry Frank

    After reading all of the fine work by several members, I decided that I wanted to add the dust bin sensor to my Oneida Super Dust Gorilla. I ordered most of the parts on eBay. The sensor was $3.79, the delay relay board was $4.95 and the 12 V power supply was $9.99. I used some LED trailer...

    Last Post By: Tom Bain Yesterday, 9:25 PM Go to last post
    derek labian

    Mitutoyo Dial Indicators Recommenation

    Thread Starter: derek labian

    I currently have a digital dial indicator with resolution of .001. I was thinking about going to an analog and a better indicator. Batteries are always dying and analog just seems easier to use. I was looking at the Mitutoyo indicators. My application will be jointer/shaper tooling setup...

    Last Post By: Charles Coolidge Yesterday, 6:44 PM Go to last post
    Dave Cav

    Fritz & Franz jig vs parallel positioner?

    Thread Starter: Dave Cav

    Or is this apples and oranges? I'm getting used to my new slider. I made a F&F jig and really like the versatility and ease of making small rips and crosscuts. I've been watching a lot of slider videos, primarily Steve from Extreme Woodworker and Sam Blasco, and I'm in the process of...

    Last Post By: Jim Becker Yesterday, 8:34 PM Go to last post
    Zachary Hoyt

    Durable and cheap flooring advice

    Thread Starter: Zachary Hoyt

    I have been trying to figure out flooring for the house I am going to be repairing and moving into in the spring/summer. It's about 100 years old with two layers of softwood T&G boards in most of the house. The kitchen is in a single story area where the floor rotted away due to the roof leaking...

    Last Post By: Zachary Hoyt Yesterday, 5:57 PM Go to last post