• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Michael Arruda

    Home Depot return policy change without notification

    Thread Starter: Michael Arruda

    Hello all, I had some small items left over from various things I've done around the house recently and decided to gather them up to take back to Home Depot. These items were purchased at various times over the past couple weeks and I of course misplaced my receipts. Meaning they got washed,...

    Last Post By: Jon Nuckles Yesterday, 6:12 PM Go to last post
    Bennie Dempsey

    3D Planning Software

    Thread Starter: Bennie Dempsey

    Hey all! I would like to start planning out my projects before I begin them, as I've heard that's a good habit to have. I can find a modeling program online pretty easily, but I wanted to see what you guys use. I am awful at hand drafting so paper and pencil isn't my go-to for personal projects....

    Last Post By: Mark Bolton Today, 5:06 PM Go to last post
    John McGovern

    Table Saw Questions

    Thread Starter: John McGovern

    Hi All, I've been lurking in the weeds for some time and have found this venue to be the most knowledgeable, helpful, and courteous forum on the block. And, I know this question has been asked and answered so many times, but I hope you all have the patience for one more dip to the well to answer...

    Last Post By: David Buchhauser Yesterday, 11:34 PM Go to last post
    Paul F Franklin

    New Lee Valley Web Site

    Thread Starter: Paul F Franklin

    Seems the roll out of the new site is not going completely smoothly. Have been trying to place an order all morning and the site just spins when I try to checkout. Tried a few different browsers too. Guess I may have to call :eek: New site design seems nice and clean though but it will take...

    Last Post By: Rob Lee Today, 3:57 PM Go to last post
    Ronald Blue

    Two Year Old Camaster Stinger III

    Thread Starter: Ronald Blue

    I have a locally available Camaster Stinger III. It's a 4 X 8 machine with a three head setup. Whats the benefit of the three head arrangement? Is it an alternative to an ATC system? What's a fair price? He says it was $18,000 new. He's discounted it a lot from that amount. Nearly half. He did say...

    Last Post By: Jim Becker Today, 10:42 AM Go to last post
    Bill Jobe

    Sill to concrete barrier

    Thread Starter: Bill Jobe

    Is just the simple rolls of foam sill vapor barrier ok for an unheated shed? Also, would it help control sound to separate the staggered studs on separate sill? That is, 2 2x4s instead of one 2x6, with perhaps a sheet of drywall or sheet rock between them?

    Last Post By: Bill Jobe Today, 12:19 PM Go to last post
  • Jen Joy

    There is no available content written by Jen Joy