Sawmill Creek Woodworking Community

Sections
Sawmill Creek News

Workshops

Woodturning

Social Woodworking

Tools

Lathes and Accessories

Table Saws and Accessories

Jigs and Fixtures

Cabinetry
Recent Articles
Recent Article Comments Widget
Hottest Threads

Time for some levity
Thread Starter: Dave Anderson NH
With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Yesterday, 11:58 AM

Squaring Boards by Hand
Thread Starter: Tom Mayock
I am new to the hand tool world. After finally figuring out how to get my hand planes sharp (due in large part to some advice I received here), I am trying to learn how to square and dimension boards by hand. I have watched a ton of videos on the process on YouTube, and I have also done a lot of...
Last Post By: Nathan Johnson Yesterday, 11:15 AM

Any chance of construction lumber prices going down in six months?
Thread Starter: Bill Dufour
Lumber is about 100% higher with covid since 12 months ago. More homes are starting to be built. Any thoughts on construction lumber prices in the next 12 months? Bill D
Last Post By: Carroll Courtney Yesterday, 4:48 PM

Vaccination Arm
Thread Starter: Tom Bender
Don't get your Covid Vaccination in your toilet paper arm.
Last Post By: Tom M King Yesterday, 3:17 PM

Track Saw vs Circular Saw vs Table saw Vs Miter saw - Which one to start with?
Thread Starter: Amelia Green
Hi, I realise that all tools are not equal. I remember someone saying that even a table saw does not equal a table saw does not equal a table saw :eek: But if someone is just getting into the woodworking hobby with a limited space available for the workshop, which one would you guys recommend...
Last Post By: Roger Feeley Today, 9:31 AM

Bee lawns
Thread Starter: Mike Soaper
So, I'm thinking about making my front lawn more bee friendly, honey bees in particular. Based on some University of Minnesota Bee Lab papers I'm going to start adding fine fescue grasses to my lawn along with some white clover. Here's some info for others thinking about making their lawns...
Last Post By: Mike Soaper Yesterday, 12:45 PM

kent wardecke

There is no available content written by kent wardecke

Recent Polls
Do you twist your wires before using a wire nut? (Votes: 48)

Yes (Votes: 36)

No (Votes: 12)
Recent Forum Posts

How to repair aluminum?

This ^^^

I repaired an aluminum water neck housing on my old car with JB Weld. It was still holding strong years later when I sold it. As
Erik Loza Today, 9:53 AM

What is this Mystery Wood?

Hickory also my gut reaction.

Erik
Erik Loza Today, 9:47 AM

Which Beginner Miter saw to Buy for my son (Dobbby)

+1 on the hearing and eye protection! Miter saws, like routers use universal motors that are very noisy. Also, miter saws are prone to flinging bits
Roger Feeley Today, 9:45 AM

1/8" Glass in 1/4" Groove - Kitchen Cabinet Doors

My wife didn’t like the dated raised panel doors in our laundry room. I removed the panels and used a flush trim bit to convert the dado to a rabbit.
Roger Feeley Today, 9:39 AM

Light At The End Of The Tunnel

+1. Very unique! Congrats on pulling that off Julie.
Brian Tymchak Today, 9:32 AM
Recent Blog Posts

Sections

Recent Articles

Recent Article Comments Widget

Hottest Threads

kent wardecke

Recent Polls

Recent Forum Posts

Recent Blog Posts