Time for some levity

With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

How to bend wood like this - Outdoor furniture project

Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...

Is there a small, accurate table saw?

I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...

AC electrical puzzlement

This morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...

cope and stick micro shaker?

has anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...

Cheap Bandsaw for Resawing

I'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...

Shop Vac for Table Saw Dust Collection

Do you use a cyclone separator with it also?

Cheap Bandsaw for Resawing

With all due respect, That's your experience, mine and others are not quite the same.
I have resawn Sapele, 9 1/2" with my Grizzly GO513 and

Stanley Bailey #7 Made in England plane

I'm impressed Steven .

Regards from Pomeroys Bar and Grill

Derek

Attaching drawer front - 1/4" thick on 1/2" Drawer frame - fastening method?

I have a drawer front that is thinAnd flexible. Only 1/4 of an inch with a 1/2 inch backing. My handle has 2 Machine screws which is fine, but the door

Stanley Bailey #7 Made in England plane

My English No. 4c..

Has been used quite a bit...

Has a groovy sole, too..

A simple little fact: Stanley

SC Pig-Picking