• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Jim Becker Today, 9:36 AM Go to last post
    Bill Jobe

    Concrete block shed for DC and compressor?

    Thread Starter: Bill Jobe

    I have quite a number of concrete blocks....enough to build the walls for a small shed to house my DC. Are there any reasons why this might not be a good idea? I'm thinking I'll pour a small slab and wet set the bottom row, then mortar the rest. Any ideas or suggestions ? Not only would this...

    Last Post By: Bill Jobe Yesterday, 9:45 PM Go to last post
    Edwin Santos

    How long a wait is acceptable at a doctor's office?

    Thread Starter: Edwin Santos

    My appointment for a consult with a new doctor was for 11:15. I showed up at 11:05 knowing I would need to do some paperwork. Finished the paperwork in about five minutes so now it's 11:10. At 12:15, after inquiring and being told the doctor is still with other patients, I walked out. No...

    Last Post By: Roger Feeley Today, 11:02 AM Go to last post
    Allan Speers

    Clear Vue Cyclones - how can they cost so little?

    Thread Starter: Allan Speers

    Well, as you all know, I recently took possession of a FREE, vintage Onieda 1.5 HP system. Thanks to the excellent replies in that thread I started, I now know that I can "kinda sorta" get by with this, in my smallish shop, but would do well to upgrade at some point. So, I'm already looking...

    Last Post By: Carl Beckett Today, 2:19 PM Go to last post
    JohnM Martin

    Shooting Planes - Are they worth it?

    Thread Starter: JohnM Martin

    I know this is a highly subjective topic (and there are probably many different opinions on it), but I thought I would ask to see what people think to see if there is some sort of a consensus. The question is regarding shooting planes. Specifically, are they worth the (relatively) high cost to...

    Last Post By: Tony Zaffuto Today, 5:27 AM Go to last post
    Mark Daily

    Table saw lubricant

    Thread Starter: Mark Daily

    Does anyone know of a good lubricant for the trunnions and other moving parts inside a cabinet table saw that wonít attract sawdust? I used PG2000 years ago with mixed results- didnít seem to lube as well as I thought it should but maybe I wasnít applying it correctly.

    Last Post By: Mark Daily Today, 12:36 PM Go to last post
  • Nick Eulau

    There is no available content written by Nick Eulau