• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Gene Pavlovsky

    Workbench height and width

    Thread Starter: Gene Pavlovsky

    There are already some discussions on this topic, but I still didn't figure what to make of them. I'm finishing Christopher Schwarz's book on Workbenches, and planning to build a Roubo workbench - my first bench. I'm 6' 3" (well, 190 cm since I live in Europe), and mostly use hand tools (my...

    Last Post By: Gene Pavlovsky Today, 4:12 AM Go to last post
    Brian Holcombe

    Wadkin DM

    Thread Starter: Brian Holcombe

    Received a small parcel today.

    Last Post By: Brian Holcombe Today, 12:52 AM Go to last post
    Jon Grider

    "Live edge lumber" musings

    Thread Starter: Jon Grider

    First, I do not wish to offend anyone, but I very well may and I apologize in advance if you are offended by my post. First rant is that I'm way over the "live edge furniture" movement. It floods the on line and Etsy/Pinterest type market and much of it imo cheapens the artistic, functional,...

    Last Post By: Don Penniman Today, 12:44 AM Go to last post
    Anthony Spotorno

    Kundig Uniq Sander Disaster

    Thread Starter: Anthony Spotorno

    About 3 weeks ago I purchased a Kundig Uniq edge sander from Holzher US. This is a very expensive machine, it was purchased NEW not used. I was told it was in stock and could be delivered asap. It finally arrived after 3 weeks and countless phone calls and emails, most of which went...

    Last Post By: Bruce Wrenn Yesterday, 9:49 PM Go to last post
    ken hatch

    New Chisel Prep

    Thread Starter: ken hatch

    I've started prepping the new chisels from Stan. I've never found a way to do it that didn't just take pulling up your big boy pants and take iron to stone and do the scut work. I wish there were an easier way, if there is I haven't found it. What this really got me to thinking about is the...

    Last Post By: Anuj Prateek Today, 4:21 AM Go to last post
    Günter VögelBerg

    How would you install this vanity?

    Thread Starter: Günter VögelBerg

    i have been asked to build a vanity similar to the one pictured here, but the bottom shelf will extend all the way to the right wall. I have studs 16 inches OC on the back wall. How would you recommend mounting this? Is there commercial hardware I can use?

    Last Post By: Mark Bolton Yesterday, 5:29 PM Go to last post
  • David Buchhauser

    There is no available content written by David Buchhauser