How to bend wood like this - Outdoor furniture project

Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...

Is there a small, accurate table saw?

I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...

cope and stick micro shaker?

has anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...

AC electrical puzzlement

This morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...

Drill w/guide or router?

Here's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...

Looking for feedback before I buy an Avid CNC

Good day all. I appreciate the time to read and give feedback. I think this is the right machine and price, but want feedback. The time has come. I need a CNC to stay competitive and I also just want to create in new ways. I have “non-buyers remorse” for stopping bidding on a beautiful 5x10...

Bosch Reaxx table saw - why you cant buy it

We recently had a thread about a proposed safety rule requiring better protection on table saws - automatic hand detection, etc. I don’t recall

Box for Cremation Ashes

The I have followed several threads about Memorial Boxes that the woodturners here at SMC have posted. There is some remarkable work back in the wood

Bottom bowl gouge shaping

Richard Raffan uses an asymmetrical grind on his deep fluted bowl gouges. The left wing is ground back for use on the outside of bowls and the more straight

How to bend wood like this - Outdoor furniture project

Here are some forms with access to both sides. I will try to dig the round window form out of the shed. It is set up like a BBQ rotisserie.

Box for Cremation Ashes

Yes, this would be helpful. Thank you!

SC Pig-Picking